Engineering

Chemical EngineeringQ&A LibraryA continuous distillation column is operating at steady state to purify alcohol from a mixture of water and alcohol. Addition of salt breaks the azeotrope and allows for more pure alcohol. Liquid containing, by mass, 55% isopropanol, 8% salt and the rest water, is fed to the column. The vapor product stream (distillate) at the top of the column flows at the same mass flow rate as the bottom liquid stream (bottoms). The vapor product stream contains 80% isopropanol and no salt.a. Define azeotrope and explain why adding salt allows removal of more water from alcohol.b. Draw and label a flowchart. Do degree of freedom analysis to see if all unknowns can be solved.c. Calculate the mass fraction of salt in the bottoms.d. Calculate the fraction of isopropanol from the feed that is in the bottoms (kg IPA in bottoms/kg IPA in feed).Start your trial now! First week only $4.99!*arrow_forward*

Question

A continuous distillation column is operating at steady state to purify alcohol from a mixture of water and alcohol. Addition of salt breaks the azeotrope and allows for more pure alcohol. Liquid containing, by mass, 55% isopropanol, 8% salt and the rest water, is fed to the column. The vapor product stream (distillate) at the top of the column flows at the same mass flow rate as the bottom liquid stream (bottoms). The vapor product stream contains 80% isopropanol and no salt.

a. Define azeotrope and explain why adding salt allows removal of more water from alcohol.

b. Draw and label a flowchart. Do degree of freedom analysis to see if all unknowns can be solved.

c. Calculate the mass fraction of salt in the bottoms.

d. Calculate the fraction of isopropanol from the feed that is in the bottoms (kg IPA in bottoms/kg IPA in feed).

1 Rating

Tagged in

Engineering

Chemical Engineering

Find answers to questions asked by students like you.

Q: A plastic (k = 0.5 W/m*K) pipe carries a coolant at –35C with a heat-transfer coefficient of 300 W/m...

A: Part (a)Inner radius of the pipe is, r1 = 3/2 cm = 1.5x102 mOuter radius of the pipe is, r2 = 4/2 cm...

Q: For a test of enzyme-catalyzed kinetics, the following data were recorded product (mmol/mL) (mmol/mL...

A: Part (a)Michaelis-Menten equation to be used is written as equation (1).The reciprocal equation of (...

Q: 1. Consider the following reaction sequence: k1 k3 ks k2 Develop a suitable rate expression for prod...

A: Part (a)Michaelis-Menten approach Write the rate expression for the first step for forward and backw...

Q: A typical column is shown in figure together with the known information for each stream. Calculate t...

A: Let the basis of the process be taken as 100 kg feed (F). Apply material balance on the overall proc...

Q: Energy conservation is important for houses. To what fraction is the heat transfer rate reduced by r...

A: For convective heat transfer through the glass window of area A ft2 having convective heat transfer ...

Q: This problem is (6.20) from a book "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: Part (d):We know that

Q: 4.4. A stream consisting of 44.6 mole% benzene and 55.4% toluene is fed at a constant rate to a proc...

A: Part (a)Let the molar flowrate of the fed stream be 100 mol/min. At the beginning, all the feed is l...

Q: 100L/hr of a 40mol% hydrochloric acid solution (25°C) is diluted with pure water (also 25°C) to make...

A: Convert the given volumetric flowrate of the 40 mol% HCl solution into its molar flowrate using the ...

Q: This problem is (6.13) from a book "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question...

Q: An aqueous solution of sodium hydroxide contains 20% NaOH by mass. It is desired to produce an 8% Na...

A: Part(a):Basis: 100 g of feed solutionIf 20% NaOH is present in the feed solution, then the mass of N...

Q: A graphite heat exchanger is constructed by drilling circular channels in a solid block of graphite....

A: Answer:For such type of problem where the other material(graphite) is trapped between two channels, ...

Q: The analysis of pesticides for environmental extracts using chromatography typically requires a solv...

A: Part (a).Let the basis of the process be 200 kg/min of the feed. Hexane is represented by ‘H’ and di...

Q: The T-x-y and P-x-y diagrams for the binary benzene-toluene system is shown below. a. The bubble po...

A: Click to see the answer

Q: Answer a - d. (a) What is the constant volume heat capacity (Cv) for HBr, assuming it is an ideal ga...

A: Dear student, we answer only threee questions in a thread. so, we are providing answers to the first...

Q: All details in question, please show all steps

A: Part (a)Michaelis-Menten equation to be used is written as equation (1).The reciprocal equation of (...

Q: 1. A closed stirred-tank reactor with two compartments is shown in Fig. El. The basic idea s to feed...

A: Assumptions:Let the heat capacity of the component be represented by C and be constant.Let the densi...

Q: A substrate is decomposed in the presence of an enzyme according to the Michaelis-Menten equation wi...

A: Part (a)Let the reaction taking place in the CSTR be, S→P According to the Michaelis-Menten equation...

Q: 5-36C The velocity of a fluid flowing in a pipe is to be measured by two different Pitot-type mercur...

A: Here in this setup we find the difference in stagnation pressure and static pressure heads of the fl...

Q: 4.7 A single equilibrium stage in a distillation column is shown in Fig. E4.7. The model that descri...

A: Part (a)Assume that the molar holdup (H) of the given stage is constant and the molar overflow which...

Q: Water at 20C with a mass flow rate of 1.0 kg/s enters an annulus formed by an inner pipe having an O...

A: Water is flowing at the rate of 1.0 kg/s in the annulus at the temperature 20°C. The inner pipe outs...

Q: A small steam superheater will be made of 0.75-in. schedule 80 stainless steel pipe which will be ex...

A: The following conditions are given in the question:

Q: A salesperson comes to the door selling a service designed to check “chimney rot”. He explains that ...

A: The reaction of methane with air is written as:

Q: Cyclohexanol is a highly desired chemical precursor for the production of nylon (billions of kilogra...

A: Part (a):Since all the derivatives are zero and y=u=0 at the nominal steady state, Hence taking lapl...

Q: Air (an ideal gas) at 90ºF and 10 psia is contained in a horizontal cylinder by a frictionless pisto...

A: Part (a) For an ideal gas work done by the gas on the piston if the expansion occurs at constant int...

Q: To evaluate the use of renewable resources, an experiment was carried out with rice hulls. After pyr...

A: Part (a)The schematic diagram of the given process is shown below.Let the basis of the calculation b...

Q: 100 mol/min of butane is combusted with 60% excess air. What is the molar flow rate of air to the co...

A: The reaction for combustion of butane is:

Q: 5.20. Multistage stripper. A stripper at 50 psia with three equilibrium stages strips 1,000 kmol/h o...

A: The process diagram of given process is given below

Q: This question I will post the second time so please help me thank

A: Dear student, we provide answers to only three parts in a question, so we are answering the first t...

Q: A liquid stream containing half n-hexane and half n-pentane at 80°C and 5 atm is fed at a rate of 10...

A: Part (a)The Antoine equation to be used is written below.Here, Pi* is the vapor pressure of the comp...

Q: In certain composition ranges of mixtures of ethylene tetrachloride (C2Cl4), isopropyl alcohol, and ...

A: Part (c)The basis of the calculation is taken as 100 lbs of feed mixture containing 40 mass% C2Cl4, ...

Q: This problem is (8.7) from a book "Thermodynamics and Statistical Mechanics An Integrated Approach ...

A: Part (a): On combining first and second law of thermodynamics, specific internal energy (u) is expre...

Q: A horizontal steam pipe has an outer diameter of 8.9 cm and passes through a large room whose walls ...

A: The formula used to calculate the heat loss by radiation is written below:

Q: A gas heater shown below in cross-section consists of a square sheet metal duct insulated on the out...

A: Part (a)The formula to calculate the equivalent diameter of the heater is:

Q: details in photo, please show all steps

A: Part (a)Michaelis-Menten equation to be used is written as equation (1).The equation used to prepare...

Q: Homework #1 1.18 Nitrogen gas can be injected into oil wells to increase the recovery of crude oil (...

A: Part (a)Note: As the table 1.2 and 1.3 was not provided with the question so, conventional symbols a...

Q: 4.8 A surge tank in Fig. E4.8 is designed with a slotted weir so that the outflow rate, w, is propor...

A: Apply material balance on the given system as:

Q: A tank holds 100 gal of a water-salt solution in which 4.0 lb of salt is dissolved. Water runs into ...

A: Let the function for amount of salt (kg) in the tank at time ‘t’ minutes be, S(t).Now, the rate of c...

Q: Problems 189 Inside the column a liquid stream fows downward and a vapor stream rises. At each point...

A: Part (a)100 mol of benzene-toluene equimolar mixture is fed into the column. ṅ1 mol/h represents the...

Q: A rectangular steel (k = 58.7 W/m * K) fin 25 mm thick and 150 mm long is attached to a wall that is...

A: Part (a)The figure representing the given question is:Let the depth of the fin be 1m as the calculat...

Q: A consulting firm has designed a steam system for a new process unit at your plant. Super heated ste...

A: Part (a)The diagram representing the cross section of the insulated pipe containing steam is shown b...

Q: 1:02 AM ll Verizon 99%- Done 4. The enthalpy of vaporization of water at 100 °C is 2256.9 kJ/Kg. Ass...

A: Watson equation is to be used as written below. Here, ΔH1 is enthalpy of vaporization at T1.ΔH2 is e...

Q: John Smith, supervisor of the process control group of the Ideal gas Company, has installed a 25 x 4...

A: Since we are entitled to answer up to 3 sub-parts, we’ll answer the first 3 as you have not mentione...

Q: .Verizon 89% 5:33 PM Done 2. A liquid system consisting of 5 % mole ethanol and the rest being water...

A: Part (a) At constant pressure, the temperature at which the liquid mixture boils is determined as sh...

Q: An annular stainless steel (k = 16.6 W/m * K) fin of thickness 5 mm and outside diameter 3 cm is att...

A: Solution:Given thatThermal conductivity=k=16.6 W/m.KHeat transfer coefficient=h= 40 W/m2.KAtmospheri...

Q: Acenapthalene has a normal boiling point of 277.5°C. At 197.5°C its vapor pressure is 100 mmHg. Esti...

A: At the given normal boiling point of 277.5°C, the heat of vaporization of Acenaphthylene is:

Q: Chemical and Bio-Process Control 4edSensor Systems:Consider flow sensor that reads 10,000 lb/h when...

A: Zero is the lowest value of the range in the measuring instrument and span is the difference between...

Q: Uric acid (UA) is degraded by uricase enzyme immobilized in porous Ca-alginate beads. Experiments co...

A: a)From units of rate in the given data (mg/L*hr), the reaction is first order and for the first orde...

Q: A 4-in. schedule 80 steel pipe (ID = 3.826 in., OD = 4.5 in.) carries a heat-transfer fluid at 600 F...

A: The schematic diagram of the pipe with insulation is given below with the inner radius R1, Outer rad...

Q: *"24.27 In the vapor-recompression evaporator shown in Figure P24.27, the vapor produced on evaporat...

A: Part (a) The schematic flow diagram for the given process is shown below. Let the system be consider...

Q: This problem is (6.30) from a book "Thermodynamics and Statistical Mechanics An Integrated Approach...

A: The information provided in the question is as follows:Inside diameter of the hose is d1 = 5 cmNozzl...